Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.

Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

---

The latest 4O3A Genius Product Software and Firmware

If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Larry _ NY8T ✭✭✭

• Activity
• Posts34
• Comments698

• Re: Don't see RF Power / SWR levels in SDR when transmitting phone

  Larry _ NY8T

  September 2017
  If you don't turn dax off it will not pass microphone audio when using mox to key the radio.
  1

• Re: Two Tone signal input ?

  Larry _ NY8T

  September 2017
  I ran my LP-700 off a battery, no improvement with the ripple wave form.
  1

• Re: Two Tone signal input ?

  Larry _ NY8T

  September 2017
  OK, so I received the 600 to 600 ohm audio isolation transformers and it solved the ripple in the wave form problem. This is inputting the 2 tone test signal into the accessory plug. I am using the p…
  1

• Re: SmartSDR Locks Up Intermittently on iPad on Fast 5Ghz WiFi

  Larry _ NY8T

  November 2017
  When i was running my linksys router i had to use 802.11 g @ 2.4 Ghz to stop the stuttering. The asus router i have now works fine on the fastest settings.
  1

• Re: Low power to no output Flex 6300

  Larry _ NY8T

  November 2017
  Make sure the power pole connectors on the back of the radio are getting a good connection. I have experienced low power due to this, also make sure your power supply is putting out close to 14 volts…
  1

Next